How To Use Ultrasonic Cleaning Machine? Ultrasonic Cleaner Supplier
Currently TOPTION this type ultrasonic cleaning machine is an ideal, efficient and accurate cleaning
equipment to clean thoroughly the instrument, meter, electronic device, circuit board, silicon dice of
a semiconductor, magnetic material, galvanized parts, hardware, optical lens, audio-frequency magnetic
1. The ultra-audio-frequency electric signal produced by the ultrasonic generator in a ultrasonic cleaning
machine is conversed to the mechanical vibration with the same frequency through the piezoelectric inverse
-transforming effect of the transducer.
2. Then it will radiate forward intensively in the cleaning solution in the form of ultra-audio-frequency longitudinal
wave(The ultra-audio frequency longitudinal wave spreads alternatively between zones of negative pressure and
3. Producing ten thousands of small bubbles to explode in turn. It’s these small bubbles which form and grow in
the zone of negative pressure, and explode instantaneously in the zone of positive pressure, to strike with high
pressure the surface, gap, and small local of a cavity to be washed, leading to peeling off of fouling quickly.
4. Thus the good cleaning and purifying effect can be reached.
1. Put water in ultrasonic cleaner.
2. Access220VAC60Hz power.
3. Turn on the power switch and press START/STOP,and LED will light.
4.The water will be vibrated,with spider net movement and vibration noise. The machine can work.
5. The cleaning solution can be put into the cleaning slot. When cleaning, level of the solution can’t be below one
third of the height of the cleaning slot, above two thirds of the cleaning slot. You should add different detergents
according to different cleaning requirements.
Thus to increase cleaning efficiency. All detergents should not fret the inferior slot and the body of the cleaning
6. According to the cleaning requirement, set the cleaning temperature.
7. Put things to be washed into the mental frame, and set the cleaning time according to the real situation of fouling
accumulation. Normally the time can be set between 3-30 minutes, and the time can be prolonged for things which
are especially difficult to be cleaned.
8. For heavy articles, suspend it through a hanger in the cleaning solution to increase the cleaning effect, heighten
the cleaning quality.
9. Take the article to be washed out; rewash or rinse with the ultrasonic machine.
If you don’t use the machine for a long tine, you should drain the cleaning solution in the slot out, and clean the body
of the machine.
Find ultrasonic cleaner supplier for hospitals, pharmacies, schools, scientific researches, petroleum, chemical
industry, light industry, metallurgy, machines, transportations, national defenses etc. , welcome contact
firstname.lastname@example.org learn more.